Triggerfish Motor Calibration

Answers to your problems from hand-picked MATE volunteers
Post Reply
lseapy
Posts: 1
Joined: Mon May 15, 2017 4:44 pm

Triggerfish Motor Calibration

Post by lseapy » Tue Apr 10, 2018 9:20 am

We have a new Triggerfish board. One motor is properly calibrated, the other is non-responsive. The motor simply is on, one direction, all the time. I suspect this is a soldering/wiring issue. Has anyone else has this problem. We don't seem to be able to set the dead zone or change direction of this one motor. Thanks for feedback!

Post Reply